Showing 0 products
Frequently Asked Questions
How do these differ from pool safety alarms?
They monitor plant rather than people.
Temperature, flow and equipment status are what they report.
Safety alarms detect a person entering the water.
Those answer a supervision requirement.
One cannot be substituted for the other.
Specifying the wrong one is a costly error.
Where should a water temperature sensor sit?
Where it reads the pool, not the heater.
Downstream of a heater it reads heater output.
The controller then shuts down early.
Swimmers never experience that temperature.
Return-line or pool-body positions are used instead.
Specify the position rather than leaving it to site.
Why is a flow switch so important?
It confirms water is moving before anything runs.
Heaters firing into static water are destructive.
Dosing into static pipework is equally bad.
The switch interlocks both.
Its failure causes more damage than any other sensor.
Test it at every service.
Wall panel or phone application?
Whichever the operator will actually use.
A lifeguard reads a wall panel at a glance.
An application nobody installed changes nothing.
Commercial sites usually need both.
Ask what happens when the network drops.
Local schedule retention is the thing to confirm.
Wired or wireless sensors?
Wired remains the default in a plant room.
Cable runs are short and conditions are harsh.
Wireless suits retrofit where cabling is impractical.
It introduces a battery replacement cycle.
Somebody has to own that cycle.
Plant rooms also attenuate radio more than expected.